Tool 5: Folic acid: capsules & trituration

Certificate-based corrections for capsule batches, stock triturations and individual doses. The 5% overage and minimum weighing threshold depend on the applicable procedure.

Frequently asked questions about Folic acid: capsules & trituration

How does the folic-acid tool handle stock and raw-material potency corrections?

For direct raw-material weighing, the tool uses the as-received potency calculated from the certificate of analysis. An existing 1% or 10% trituration must already be correctly prepared on a pure folic-acid basis; the raw-material correction is not applied again. Any separate 5% low-unit-dose overage follows the selected setting.

Which certificate-of-analysis values do I need for folic acid potency correction?

Use water content and dry-basis assay from the same raw-material batch. Analytical assays above 100% are accepted, but require checking the method, units and chemical form. Blank certificate fields are never treated as 0%.

When should I use the three folic-acid calculation modes?

Use Capsules to calculate a capsule-batch weighing, Trituration to prepare stock at a chosen concentration and final mass from the certificate of analysis, and One capsule to calculate a single dose from direct weighing or a previously prepared, correctly adjusted 10% or 1% trituration. The tool applies its 100 mg reference weighing threshold and may block a weighing below it.

Checking access…